Hello, guys. Welcome to another paper airplane tutorial. And today I’m going to show you guys how to make a paper airplane. This is my new design, and I created it based underclasses dark. So if you question the origin of the plans, look at the traditional classic dot. You see some similarities. But this one is totally different in terms of flying because it’s a boomerang plan and it’s designed to boomerang.
Materials / Materiales
- A sheet of U.S. Letter Size(8.5 in*11 in) or
- A sheet of A4 Paper Size(21 cm*29.7 cm)
- 1 Pair of Scissors
- 1 Ruler
- And 1 Pen
I will use the bone folder to have me fold a paper. Now let’s start. So first step, let’s fold the paper in half this way.
Make sure you folded the paper correctly. After that unfold the paper. You will see a line that has been made in the middle. According to the line we have to do the next step. Fold the paper two times in two left corners along the middle spot. Slowly press the paper down. Then make strengthen the paper fold with anything. And repeat the same fold for the other side.
The next step Then extends the corner of the left side along the middle of the right side.
And then unfold the paper on the following step. Now you have to fold again along the red spot shown in the middle.
That’s exactly what it looks like. Make sure it is along the middle.
Then we will turn the paper upside down. now we start to fold the top two sides. One side first and then the next side. All right. You need to make sure that both sides come to the same place. Look at this.
On the following step Let’s fold the remaining paper at the top.
Then turn the paper in the opposite direction. Then fold along the middle of the paper. That’s exactly what it looks like. Hope you follow the steps above correctly.
Then you need to fold your paper again along the line shown below. Fold the paper from top to bottom by pressing with the hand along the red spot shown below. Now fold the paper on the opposite side in exactly the same way.
Now we are almost at the end. Now, at the end of the paper, we need to create the elevators. Is this also the stabilizer. So what size can it be? It is very good if it is 1.5 cm. You follow me below.
And then I flip the paper over. Repeat the same fold for the other side. Remember that the other fold size will be equal.
And then I flip the paper over. Repeat the same fold for the other side. Now I have the other edge. Then adjust it to your liking. OK, here we go. This is awesome. The paper airplane is almost finished. Let me flip the paper over and then open the stabilizer measure that is perpendicular to the wings.
And then at the end, the wings. I would create a small pinch elevated for this. Then we can also create pinch the other side. Here we go. And here you go to throw this paper here. If you want it, come back to you, just a little bit, and then throw it in the direction that you want it to come back to you.
So to a little bit poet angle at 35 degrees and throw it toward the direction you want it, come back. Fine example. And you want to come back to the left. You have to hold it like this and they throw it to the left a little bit and it’s come back to you.
You want it to come back to the right to it to derail it a bit and they make that throw. And here you go. This is the new awesome but Morand paper plan. I hope you guys enjoy making this airplane.